1993 GMC Jimmy Problems
RepairPal has identified the most common problems with the 1993 GMC Jimmy as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.
Vehicles using the enhanced vortec V6 engine may be hard to start run poorly and/or use to much fuel due to a fuel leak inside the intake manifold plenum. Commonly this is caused by a leaking fuel pressure regulator or fuel line. The fuel system will need to be pressurized with the upper intake manifold removed in order to determine the exact cause of the leak. Removing the "tuning valve" from the upper intake can allow for limited visual inspection without removing the upper intake manifold.
The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.
A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.
4.3L V6 multi-port FI only
The exhaust gas recirculation valve (EGR) may stick open causing a rough idle and the Check Engine Light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.
The transmission output shaft seal may leak transmission fluid. On 2WD models, this leak can cause the transmission mount to become oil soaked, which will require replacement of the mount along with the leak repair. On 4WD models, if this seal leaks, the fluid will leak into the transfer case, causing it to become overfull.