If the engine runs rough, stalls, hesitates on acceleration, is hard to start, or has generally poor performance, this can be caused by a cracked or broken air inlet tube. Loose clamps on the air tube can also cause this these problems. Tightening the air inlet tube, or replacing if broken, should correct the problem.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 1993 Ford Probe problems
Water corroding the head light actuator connector can cause the head lights to open and close on their own, or operate erratically. Replacing the head light actuator motor should fix this problem.
A defective oil pump can cause ticking noise from the engine, stalling, rough running, and reduced engine power. Replace the oil pump if this is found to be the cause.
If a buzzing noise is coming from the exhaust at different engine speeds and conditions, this is commonly caused by the heat shields on catalytic converters coming loose at points. The buzzing is the metal on metal contact. Installing a large worm clamp around the catalytic converter and heat shield assembly will prevent the noise and secure the shields.
If the mass air flow sensor is not working properly, the Check Engine Light can come on, the engine can hesitate while accelerating, has reduced power, and a rough idle. Replacing the mass air flow sensor should fix this concern if the diagnostic trouble codes confirm the mass air flow sensor is the cause.
A clunk noise in the steering when turning from left to right can be caused by insufficient pre-load adjustment on the steering rack. Adjusting the pinion pre-load should correct this concern.
The fuel cutoff light came on and it came to a complete stop and will not restart. Tried resetting the switch and it wasn't tripped. I have no clue whats going on with it.