Close

2000 Dodge Dakota Problems

RepairPal has identified the most common problems with the 2000 Dodge Dakota based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
14
Known Problems

Front and rear differential pinion seal leaks are common. The leaky pinion seal and differential fluid will need to be replaced.

If the threads strip where the front brake caliper mounts to the steering knuckle, a steering knuckle repair kit is available. A new steering knuckle is not normally necessary.

On 3.7L V6 and 4.7L V8 engines the camshaft position sensor may fail causing the engine to crank but not start or it can cause intermittent stalling. A failed camshaft position sensor will require replacement.

A clunk or popping sound heard while turning may mean the intermediate steering shafts need realignment. Replacement of the upper intermediate shaft may be necessary.

On the 3.9L V6 and 5.2L V8, an intermittent connection in the crank position sensor wire connector can cause poor engine performance or the engine may crank but not start.

Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.

On the 3.9L V6, 5.2L V8 and 5.9L V8 the Oil leaks commonly from the valve cover gaskets, intake manifold gaskets (front and rear), timing cover gaskets, distributor O-ring, and the rear main seal area. Using fluorescent engine oil dye can be helpful in determining the source(s) of the oil leak.

If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.

3.7L V6 and 4.7L V8
Exhaust manifold bolts commonly break, exhaust manifold gaskets should be replaced and replace bolts as needed.

The upper ball joints may fail due to moisture damage. Our technicians tell us 2000-2001 models were recalled for this issue. For more information on this recall, please click here»

On the 3.9L V6 and 5.9L V8 the engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.

On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.

If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.