1998 Dodge Dakota Problems
RepairPal has identified the most common problems with the 1998 Dodge Dakota as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.
If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.
On 3.7L V6 and 4.7L V8 engines the camshaft position sensor may fail causing the engine to crank but not start or it can cause intermittent stalling. A failed camshaft position sensor will require replacement.
On the 3.9L V6 and 5.2L V8, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.
If the threads strip where the front brake caliper mounts to the steering knuckle, a steering knuckle repair kit is available. A new steering knuckle is not normally necessary.
A clunk or popping sound heard while turning may mean the intermediate steering shafts need realignment. Replacement of the upper intermediate shaft may be necessary.
Front and rear differential pinion seal leaks are common. The leaky pinion seal and differential fluid will need to be replaced.
On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.
A water leak from the roof seam at the rear of the cab can look like the windshield seal is leaking at the upper corners. If the water leak is not from the windshield, the roof seams and fasteners holes should be sealed.