2000 Chrysler Voyager Problems
RepairPal has identified the most common problems with the 2000 Chrysler Voyager based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
Intermittently, the key may not start the car or release from the ignition. If it is excessively worn, replace the key. If the new key doesn't work, replacing the lock cylinder including tumblers should correct this concern.
Illuminated of the airbag warning light may be caused by a lost connection between the clockspring (behind the steering wheel) and the steering wheel-mounted electrical components. Other steering wheel-mounted controls like the horn, speed (cruise) control, or radio controls (if equipped) may be inoperative. There is a lifetime warranty on the clockspring as specified in a combination of recall campaigns. For more information on these recalls please us the following links; 1996-1998 models, please click here». For 1998-2000 models, please click here»
On higher-mileage vehicles, engine oil leaks from the valve covers and front crankshaft seal are common.
A dirty throttle body may cause low engine idle speed or frequent stalling, as oily residue blocks air flow in the throttle when the throttle is closed. Throttle body cleaning may be necessary to correct this condition. Our technicians caution against spraying cleaner directly onto the throttle body as this may damage the throttle position sensor (TPS).
A delay in the transaxle engagement (greater than three seconds) may have multiple causes, including a defective pump, defective internal lip seals, valve body components, park-reverse-neutral-drive lever switch, and the output speed sensor. Proper diagnoses will be necessary to determine the exact cause.
AWD equipped vehicles can show a wide range of transmission problems, often caused by using the wrong-sized and/or mismatched tires. Be sure that all the tires are the same and that all four are replaced at the same time. Dodge recommends tire rotation every 7,500 miles.
If the transmission is slipping in first gear or Reverse—or if you experience delayed or loss of gear engagement after initial startup—the transmission may require removal and disassembly.
If the door lock actuators (integrated into the door latch assembly) are noisy and/or not working, the latch should be replaced. For some model years, the actuator for the sliding door is available separately from the latch.
Coolant leaks coming from the underbody on vehicles equipped with rear heat/AC are common. The underbody hoses should be inspected as part of regular maintenance. If you drive on roads where salt is prevalent the problem is generally more severe.