2006 Chevrolet Tahoe Problems
RepairPal has identified the most common problems with the 2006 Chevrolet Tahoe based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault. The warranty has been extended on some of these units to 7 years or 70,000 miles.
The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2000-2003 models is #4114K (trade number).
The rear window defogger may stop working due to a wire terminal broken off of the rear glass. Our technicians tell us that terminal can be reattached using a special glue or silver solder.
The 2004-2007 Chevrolet Tahoe has known issues with the EVAP system, a part of your emission control system.
To correct the issue, the EVAP canister vent valve, solenoid, and wiring must be inspected. The most common fix is replacement of the wiring connector or replacement of the vent valve assembly.
The headlight switch used on the Chevrolet Tahoe is known to fail through normal operation. Since the headlight switch is also integrated into the interior lights, a malfunctioning switch can cause issues with interior lights as well.
- Symptoms of a failed headlight switch include:
- Headlights and taillights failing to turn on or off
- Interior lights flicker, or fail to turn on or off
- Gauge cluster lighting off or flickering with headlights on
- Parking light malfunctions
This issue is well known with General Motors Trucks and SUVs, and is solved by testing and, if needed, replacing the headlight/dimmer switch. Bad grounding wires at the tail-lights, and dirty/corroded tow package wires can also lead to some of these issues.
The steering may develop a clunk type noise from the upper intermediate steering shaft. Our technicians tell us that you should check with you local GM dealer to find out what the latest repair is for this condition.
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
The sunroof may stop working for various different reasons. Our technicians tell us it is often better to replace the complete sunroof assembly than to try and repair the old one.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.