2000 Chevrolet S10 Problem Reports

Most Reported 2000 Chevrolet S10 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

Illumination of the Check Engine Light may be the result of a loose or worn gas cap.

The CD player in the radio may fail. Our technicians tell us that the radio will need to be removed and sent out to a radio repair shop to correct this condition.

The serpentine belt tensioner can fail; it may become noisy and/or the belt may jump off. Replacement of the failed tensioner will be necessary.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.

The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module assembly if this condition occurs.

A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.

The metal brake line corroded away, and without warning failed completely. My truck was built in 2002 and during that time GM did not use stainless steal for the brake lines. Living in PA, we use salt on our roads during snow events. This salt corrodes away the non stainless steal break lines. If you have a GM vehicle made from 1999-2003, check to see if the SS was OEM spec. If not, have your shop check for any corrosion along the brake lines ...

Dripping oil all over driveway. The oil pan gasket was replaced after warranty ran out! Parts and labor was $1,187! Found out it was a common problem with the 2.2l engine.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.