» » »

Problems for specific Chevrolet S10 years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Most reported 1995 Chevrolet S10 problems

 

Verified for the Chevrolet S10

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

67 Reports
Me Too

Verified for the Chevrolet S10

The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.

38 Reports
Me Too

Verified for the Chevrolet S10

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

33 Reports
Me Too

Verified for the Chevrolet S10

On vehicles with intermittent windshield wipers, the wiper motor circuit board may fail and cause the wipers to stop working at times. Replacing the circuit board should resolve the issue. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.

18 Reports
Me Too

Verified for the Chevrolet S10

The serpentine belt tensioner can fail; it may become noisy and/or the belt may jump off. Replacement of the failed tensioner will be necessary.

17 Reports
Me Too

Verified for the Chevrolet S10

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.

16 Reports
Me Too

Verified for the Chevrolet S10

The electrical contacts in the ignition switch may fail and result in erratic instrument panel gauge operation or illumination of the Check Engine Light. A failed ignition switch will require replacement.

14 Reports
Me Too

Verified for the Chevrolet S10

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

13 Reports
Me Too

Verified for the Chevrolet S10

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

12 Reports
Me Too

Verified for the Chevrolet S10

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

10 Reports
Me Too

Verified for the Chevrolet S10

The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.

9 Reports
Me Too

Verified for the Chevrolet S10

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.

7 Reports
Me Too

Verified for the Chevrolet S10

The alternator may fail, causing a "no charge" condition. An internal bearing may also fail and cause an abnormal noise. If the vehicle is driven too long with a failed bearing, the alternator may stop turning, which can cause the serpentine belt to break or the engine to stall and not turn over.

6 Reports
Me Too

Verified for the Chevrolet S10

A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.

6 Reports
Me Too

Verified for the Chevrolet S10

An oil leak may develop from the distributor o-ring seal requiring replacement of the seal.

6 Reports
Me Too
Ask a Question