1995 Chevrolet S10 Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 1995 Chevrolet S10
- Truck has rough idle when in gear when sitting on brake.
- truck does not turn neither cranks. Loses all electrical power when turning key
- Need wiring harness, is there any other that will interchange?
- My 1995 s 10 runs really bad on and off. I have replaced the temp control sensor
- Why does the engine stumble when warm when accelerating. plus.
1995 Chevrolet S10 Problems
The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.
1995 Chevrolet S10 Questions
The truck has a non-rhythmic shaking to it when its in any gear other than park and your just sitting, like at a stoplight. Gets worse after driving for awhile, and seems to be a bit more noticeable when in reverse. 130,000 miles, tuned up less than a year ago.
its a 2.2 liter manual
My 95 chevy s 10 4.3 Z Started running really bad sometimes to the point it will shut off. The transmission stops shifting like it should when this is going on. I was told that the temp control sensor was bad. I replaced the sensor 2 times and a tune up and I still have this problem on and off. I...
1995 Chevrolet S10 Recalls
1995 Chevrolet S10 Reviews
im changing a starter on a 1995 chevy s10 4 cyl do i need to drop the exhalst pipe
Our S10 Pickup Extended Cab with 5-speed manual gearbox and the 2.2L 4-cylinder engine was cheap on gasoline, good little pickup to carry few tools and small load of materials to do small jobs. Both front ball joints replaced at around 85,000 miles. Trouble with the windshield wiper motor and the A/C compressor also went out.
1995 Chevy S10...Love, love, love my little truck. BUT, if I need to get anything done to the engine, it is a major undertaking. I had an oil leak and the mechanic told me it was the oil pan gasket. The engine needs to be pulled out to do this job. That is a ten hour job! At mechanics prices, it's cheaper to buy oil for the next five years to replaces what leaks. ( The oil leaks ended up only b...