1996 Cadillac Seville Problems
RepairPal has identified the most common problems with the 1996 Cadillac Seville as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Illumination of the Check Engine Light may be the result of a loose or worn gas cap.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
The parking brake may not release automatically due to a failed vacuum switch or actuator. Our technicians tell us that if vacuum is supplied to the actuator when the transmission is in gear, the vacuum switch is functioning and replacing the actuator should correct this concern.
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
Vehicles equipped with the 4.6L engine may develop excessive oil consumption. Please be advised that under optimum driving conditions, using one quart of oil every 2000 miles is acceptable. This Cadillac standard applies to vehicles with less that 50,000 miles. Our technicians tell us that if you experience excessive oil consumption it may be caused by built up on the piston rings which restricts movement, preventing them from wiping all the oil from the cylinder walls. Oil left behind is then burned during the combustion process. There is a special ring cleaning procedure which can help this situation. The GM service bulletin number is #02-06-01-009C.
An intake manifold vacuum leak can develop from a variety of sources, often causing illumination of the Check Engine Light with codes P0171 & P0174 stored. Thorough diagnoses will be necessary to pinpoint the cause in order to make the correct repairs. A "smoke" machine is often used to isolate the cause of difficult to find vacuum leaks.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.