Close

2001 Chrysler 300M Problems

Find the most common issues based on 2001 Chrysler 300M owner complaints.
Tap theto learn more about the most common 2001 Chrysler 300M problems.

Most Common 2001 Chrysler 300M Problems

A damaged cam position sensor (or its wires and connector) can cause intermittent stalling, stumbles, or hard starting.
Worn sway bar bushings or sway bar end links may cause a rattling or clunking noise from the front suspension during low-speed driving. Though not always the root cause, front struts are often repl...
The window glass lift plates tend to bend or break and cause the window glass to tilt and bind in the door. The lift plates can be replaced separately from the window regulator. In more severe case...
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
Looking for a particular 2001 Chrysler 300M problem?

1 Known 2001 Chrysler 300M Brakes Problem

There was a recall on the brake master cylinder in order to fix a problem that causes the brakes to drag when the brake pedal is not pressed. If the brakes drag, they will fade, causing overheating...

1 Known 2001 Chrysler 300M Drive Train Problem

Fatigued or broken wires to the output speed sensor can cause problems with the cruise control, erratic shifting, and speedometer operation. This may also cause Check Engine Light illumination.

2 Known 2001 Chrysler 300M Electrical & Lights Problems

On vehicles equipped with side airbags, placing articles under the seat can damage wiring. Loose, damaged, or dirty connectors under the seat are frequent causes for intermittent airbag lamp illu...
The instrument cluster may illuminate randomly to its full brightness and/or the fuel gauge may drop to the empty position. Typically the symptoms are infrequent and the instrument cluster returns ...

7 Known 2001 Chrysler 300M Engine Problems

A damaged cam position sensor (or its wires and connector) can cause intermittent stalling, stumbles, or hard starting.
A dirty throttle body may cause low engine idle speed or frequent stalling, as oily residue blocks air flow in the throttle when the throttle is closed. Throttle body cleaning may be necessary to...
When a no start condition is caused by a faulty camshaft or crankshaft sensor, related fault codes stored in the powertrain control module (PCM) should not be trusted. Our technicians tell us that ...

0 Known 2001 Chrysler 300M Exhaust & Emissions Problems

2 Known 2001 Chrysler 300M Heating & Air Conditioning Problems

Poor output from the heater and/or engine overheating can be caused by air left in the cooling system after the cooling system has been serviced. Our technicians tell us the proper coolant fill pro...
Some vehicles may develop a musty odor coming from the HVAC system, Dodge has issued a cleaner/disinfectant and a coating for the evaporator designed to inhibit bacterial growth.

0 Known 2001 Chrysler 300M Maintenance Problems

4 Known 2001 Chrysler 300M Miscellaneous Problems

The window glass lift plates tend to bend or break and cause the window glass to tilt and bind in the door. The lift plates can be replaced separately from the window regulator. In more severe case...
Door weatherstrips mounted on the body tend to shrink with age, leaving gaps that can create wind noise or allow water to leak into the car. Our technicians suggest the door weatherstrips should ...
If the ignition key does not turn and/or cannot be removed, a new lock cylinder may be needed. A worn key can also cause similar problems.

1 Known 2001 Chrysler 300M Suspension & Steering Problem

Worn sway bar bushings or sway bar end links may cause a rattling or clunking noise from the front suspension during low-speed driving. Though not always the root cause, front struts are often repl...

18
Known 2001 Chrysler 300M Problems & Complaints

Poor output from the heater and/or engine overheating can be caused by air left in the cooling system after the cooling system has been serviced. Our technicians tell us the proper coolant fill pro...
The instrument cluster may illuminate randomly to its full brightness and/or the fuel gauge may drop to the empty position. Typically the symptoms are infrequent and the instrument cluster returns ...
A damaged cam position sensor (or its wires and connector) can cause intermittent stalling, stumbles, or hard starting.
When a no start condition is caused by a faulty camshaft or crankshaft sensor, related fault codes stored in the powertrain control module (PCM) should not be trusted. Our technicians tell us that ...
Before refilling the coolant, make sure the air bleed valve is open. Follow the proper fill procedure—it will prevent problems with overheating, low heat output from the heater, and possib...
There was a recall on the brake master cylinder in order to fix a problem that causes the brakes to drag when the brake pedal is not pressed. If the brakes drag, they will fade, causing overheating...
A dirty throttle body may cause low engine idle speed or frequent stalling, as oily residue blocks air flow in the throttle when the throttle is closed. Throttle body cleaning may be necessary to...
Fatigued or broken wires to the output speed sensor can cause problems with the cruise control, erratic shifting, and speedometer operation. This may also cause Check Engine Light illumination.
Some vehicles may develop a musty odor coming from the HVAC system, Dodge has issued a cleaner/disinfectant and a coating for the evaporator designed to inhibit bacterial growth.
The window glass lift plates tend to bend or break and cause the window glass to tilt and bind in the door. The lift plates can be replaced separately from the window regulator. In more severe case...
If the exterior side view mirror glass breaks, replacement glass pieces are available from MOPAR (the automobile parts and service arm of Chrysler). It is not always necessary to replace the mirror...
On vehicles equipped with side airbags, placing articles under the seat can damage wiring. Loose, damaged, or dirty connectors under the seat are frequent causes for intermittent airbag lamp illu...
Worn sway bar bushings or sway bar end links may cause a rattling or clunking noise from the front suspension during low-speed driving. Though not always the root cause, front struts are often repl...
If the ignition key does not turn and/or cannot be removed, a new lock cylinder may be needed. A worn key can also cause similar problems.
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
Researching a 2001 Chrysler 300M?
Get maintenance costs, reviews, recalls and more.