Front upper strut mounts may wear prematurely, resulting in loud noise from the front of the vehicle when going over bumps.
2008 Volvo S80 Problem Reports
Most Reported 2008 Volvo S80 Problem Reports
Many complaints have been reported regarding Volvo S80 transmission shifting issues. Long shift times between gear shifts, hard shifting, hard downshifting and a loss of transmission operation all together to name a few.
If the issue is minor, a transmission software update may address this issue so if available, the software should be updated before any repairs are made. After a software update or repair, the shift adaptation needs to be reset. A good quality Volvo repair shop will know how to perform this task.
There are several technical service bulletins (TSB's) available from Volvo that address these shifting issues and they should be consulted by the repair shop during the automatic transmission diagnostic process.
Regular servicing of the transmission fluid can help with preventing transmission failure, but not in all cases. Follow the suggested fluid replacement interval recommended by Volvo. You will find this in your owners manual, or find it here: http://bit.ly/Volvo_Owners_Manuals
The front control arm bushings wear out, resulting in alignment issues and squeaking and/or knocking noises from the front end. Worn bushings will require replacement.
It is not uncommon for the exterior light bulbs to burn out prematurely. No repair option has been reported other than replacing the failed bulb.
at 103K the Car began a high pitched hum or squeal after the car warmed up. The squealing could be temporarily stopped by pressing the accelerator. The car was diagnosed as a cracked breather box, also known as, the flame trap, the oil trap. A small plastic box connected to the PCV System that has a plastic nipple that cracks and squeals form the oil pressure. The repair is difficult to get to and costs a lot in labor. My technician told me t...
The anti-lock brake system (ABS) warning light and/or other dash warning lights may illuminate due to a failed ABS Control Module. Replacement of the failed module is generally required to correct this concern.