2011 Volkswagen GTI Problems

RepairPal has identified the most common problems with the 2011 Volkswagen GTI as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
4
Known Problems

Popping sounds from the rear of the vehicle may be heard moments after starting the engine, or when slowing to a stop. This noise is from the leak detection pump filling the fuel tank with air, and releasing to retest the system when it finds a fault. The sequence of faults identifying this issue are as follows:

  • Succession of loud pops from rear of vehicle
  • Pops go away, and fuel economy decreases 
  • Check engine light illuminates
  • OBD trouble code P2404 and/or P0441 is stored
  • Engine will not start after refueling (must crank for over 30 seconds)
  • Vibration when slowing to a stop

The cause is a valve which is mounted on the front of the intake manifold, commonly called the N80 valve, or EVAP system purge valve. The valve is designed to open under specific circumstances, but a worn valve will remain open at all times, preventing the pressurization of the fuel tank. 

Correction of the issue is to replace the N80 valve with the latest revision. 

N80

The 2006-2016 GTI uses FSI and TSI direct injection engines. These engines are subject to carbon buildup in the intake system which can cause power loss, OBD codes and a check engine light, and a rough idle. In normal engines, the engine is cleaned by the gasoline flowing through the injectors and into the intake system, however, since the GTI uses direct injection, gasoline does not flow through common carbon buildup areas. 

Possible trouble codes include: P0300P0301P0302P0303P0304.

The solution is to remove the intake manifold and professionally clean the intake manifold, intake ports on the cylinder head, and the intake valves. This may need to be done in as few as 20,000 miles. 

Condensation in the heater case may cause a musty odor from the heating, ventilation and AC (HVAC) system after sitting for two hours or more. Our technicians tell us that a cleaner is available for the heater case and the drain system should be checked for debris.

The Check Engine Light may illuminate because of evaporative (EVAP) emission failures and/or intake manifold vacuum leaks.