Close

2007 Toyota RAV4 Problems

RepairPal has identified the most common problems with the 2007 Toyota RAV4 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
8
Known Problems

The Evaporative system may have problems with the vapor canister releasing charcoal pellets that plug the vent valve. Typically a Code P0441, P0442 and P0446 will be set. The key code is the P0446 which is a vent valve electrical failure. The proper repair is to replace the entire canister with all the valves as a unit. This is located on top of the fuel tank and is expensive. Our Technicians tell us that for awhile Toyota was covering these problems, but this may have changed. It would not hurt to call the dealer if this problem occurs to see if Toyota is still helping with these repairs.

Drivers of the Toyota RAV4 may notice excessive oil consumption between oil changes, even to the extent of the engine oil warning light displayed on the multi-function display.

This issue is known to be caused by infrequent oil changes causing engine sludge, or worn piston rings. 

The engine should be cleaned of oil sludge, and if oil consumption remains excessive, the engine may need new piston rings, or other internal components replaced. 

To avoid this issue, change the engine oil and filter every 3,000 miles, and ensure the proper grade of oil is used. 

One or more oxygen sensors may fail resulting in illumination of the Check Engine Light.

The head gasket may fail due to a defect in manufacturing of the cylinder block.

On this vehicle, the head bolts are known to pull the threads out of the engine block, allowing the head to slightly lift, and causing head gasket failure. Symptoms may include:

  • Overheating
  • White smoke from exhaust
  • Rough running conditions and/or inability to start or idle
  • White or cream colored oil on dipstick
  • Check engine light 
  • OBD Trouble Codes P2181, P0300

When the head gasket fails, the bolt holes for the head bolts must be repaired before the cylinder head can be remounted. 

This issue is not always preventable, but to help avoid it, never run the engine if the engine temperature is ever above the normal range. 

The VVT-i oil line is known to burst. This is a very large leak which covers the ground, engine, and undercarriage.

If the oil line ruptures while driving, the low engine oil message and engine oil pressure warnings will illuminate. Continued use after these warnings will result in complete engine failure due to oil starvation.

The line is known to be defective, and a revised part has been issued by Toyota, however, this revised part is known for the same issue.

To repair the issue, the line must be replaced, and the engine bay and undercarriage must be cleaned thoroughly.

If the car will not start, the most likely problem is worn or corroded solenoid contacts in the starter. Usually, these parts can be replaced without purchasing a new starter.
In some vehicles, the automatic transmission over heat light may come on after sustained highway driving or driving at a sustained speed. Our technicians tell us that flushing the transmission and changing from Dextron lll to Dextron ll can help remedy this problem