1995 Toyota Previa Problem Reports

Most Reported 1995 Toyota Previa Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified
The idle air control motors tend to become carboned up at around 100,000 miles and will cause a start and stall and/or stalling at stop sign problems. Many times these valves can be cleaned, however, the sure bet is to replace the idle air control motor and clean the throttle body.

It is very important that the rear level sensor is properly bled after any brake work or the rear brake stopping efficiency may be compromised. The Front Brake Rotors can wear causing a pulsation felt in the brake pedal.

A code P0770 or P0773 may occur at higher mileages which indicates that the 3-way lock-up solenoid could be defective and may need replacement.

Occasionally, the mass air flow sensor can go lean and set a code P0170 for fuel system lean. This in not an oxygen sensor problem. If there are no vacuum leaks, the mass air flow sensor may need to be replaced. Our technicians remind us to use a factory part because the aftermarket rebuilds are very inconsistent.