2007 Toyota Highlander Problems
RepairPal has identified the most common problems with the 2007 Toyota Highlander based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The head gasket may fail due to a defect in manufacturing of the cylinder block.
On this vehicle, the head bolts are known to pull the threads out of the engine block, allowing the head to slightly lift, and causing head gasket failure. Symptoms may include:
- White smoke from exhaust
- Rough running conditions and/or inability to start or idle
- White or cream colored oil on dipstick
- Check engine light
- OBD Trouble Codes P2181, P0300
When the head gasket fails, the bolt holes for the head bolts must be repaired before the cylinder head can be remounted.
This issue is not always preventable, but to help avoid it, never run the engine if the engine temperature is ever above the normal range.
A problematic center airbag sensor can cause the airbag malfunction light to illuminate.
Sludge can build up in the engine because Toyota did not recommend frequent enough oil changes. Lexus will sometimes offer a discount on cleaning the engine if necessary. Owners who changed their oil every 3,000 miles did not experience these problems. This sludge build up can lead to excessive oil consumption.
The VVT-i oil line is known to burst. This is a very large leak which covers the ground, engine, and undercarriage.
If the oil line ruptures while driving, the low engine oil message and engine oil pressure warnings will illuminate. Continued use after these warnings will result in complete engine failure due to oil starvation.
The line is known to be defective, and a revised part has been issued by Toyota, however, this revised part is known for the same issue.
To repair the issue, the line must be replaced, and the engine bay and undercarriage must be cleaned thoroughly.