Chevrolet Silverado 3500 Problems
RepairPal has identified the most common problems with the Chevrolet Silverado 3500 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The 2004-2007 Chevrolet Silverado 3500HD has known issues with the EVAP system, a part of your emission control system.
To correct the issue, the EVAP canister vent valve, solenoid, and wiring must be inspected. The most common fix is replacement of the wiring connector or replacement of the vent valve assembly.
The 2001-2002 Chevrolet Silverado 3500 has a known issue with the air pump check valve which causes illumination of the check engine light. There are no notable symptoms, but the vehicle will not pass state inspection or smog testing.
When the valve fails, it sticks closed, and the computer sets the code P1416. Replacement of the check valve is the only fix, as the valve is not serviceable.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
The fuel pump may fail causing the engine to stall and not restart.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.
A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.
One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.