1995 Porsche 968 Problem Reports

Most Reported 1995 Porsche 968 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified
Pinion bearing failure can cause noise in the manual transmission. A revised assembly procedure and components are required for repair.

In automatic transmissions, the flexible hub at the engine flywheel may deteriorate and fail, causing a large amount of play in the driveline. This failure may be caused by prolonged engine oil leaks.

The dual mass flywheel can fail and cause symptoms like noise and chatter when operating the clutch and changing gears.

Aged brake fluid can cause numerous problems and should be replaced regularly.

The constant velocity (CV) boots and CV joints should be inspected at each service. Servicing the torn CV boots early can prevent the need to replace the CV half shaft or CV joint.

If engine misfiring, rough running, or fuel consumption issues are not resolved quickly, the catalytic converter can overheat and fail.

Pay close attention to warning lights and have the brakes inspected regularly—immediately address any brake problems. Hard driving habits will cause excessive brake pad and rotor wear.
Timing belt life cannot be ascertained by inspection only. The timing belt and water pump must be maintained using the correct belt-adjustment tool. 

Suspension components (including control arms, boots, and ball joints) are critical and require regular inspection.

The tensioner for the camshaft chain must be inspected regularly because the non-metallic pad for the timing chain variocam adjuster can crack/break apart unexpectedly. The inspection/repair will require valve cover removal and reinstallation.
The cooling system must be inspected regularly, as small leaks can develop at the reservoir. The heater valve and fan operation should also be inspected.

The front hood and rear deck lid support struts may fail; replacement is required.