2006 Mercedes-Benz SL600 Problems
RepairPal has identified the most common problems with the 2006 Mercedes-Benz SL600 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
Engine misfires (rough running) and lack of power are commonly caused by ignition coil pack or ignition module faults. Proper diagnoses should isolate the cause and prevent unnecessary replacement of good parts.
Front thrust arm and control arm bushings can crack and sometimes tear completely. If this is not repaired quickly, damage to the front subframe unit will occur, which is very expensive to repair. Updated control arms (that prevent damage to the subframe when the bushings wear out) are available.
The early versions of the central gateway module (which allows different systems to communicate with each other) have software problems.
Leaks in the pneumatic system will cause problems with the dynamic seats and the trunk and/or door closing assist.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
The active body control system can leak fluid from numerous areas, including the tandem pump, hydraulic lines, struts, and/or seals. If it is not repaired, the vehicle ride height could drop too low and cause damage to the undercarriage.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.
This vehicle has sensotronic brake control (SBC). If the SBC light on the dash illuminates, have the brakes checked. If the SBC is not working, limited brake pressure is delivered to the front brakes, increasing the distance it takes to stop. The SBC hydraulic unit has a specific service life programmed into the control module. Follow the manufacturer's recommended service procedure for proper maintenance of the SBC.