The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors. The brake rotor surfaces become uneven, causing a lip to form at the outer edge. This will generally require replacement of the rotors when the pads are worn (pad life varies depending on driving style and terrain).
Problems for specific Mercedes-Benz S600 years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 1999 Mercedes-Benz S600 problems
Problems with the pneumatic system can cause closing assist and door lock issues.
One or more door windows may stop working due to a failed window regulator. Replacement of the failed regulator will be necessary to correct this concern.
Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower motor.
The engine wiring can degrade because the insulating material falls off leaving the bare wire exposed. This can cause many problems depending on which wires are exposed and what they touch.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
The lower control arm bushings can wear and crack, resulting excessive movement at the control arm pivot point, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
Vehicles with automatic level control that ride harshly in the rear (no give in the suspension) may have one or both dampening actuators which have failed. It is commonly recommended the actuators be replaced in pairs.
A refrigerant leak may develop from one or more of the following AC components: AC compressor, hose manifold for the compressor, or the evaporator core. The loss of refrigerant can cause poor AC performance. Our technicians tell us that proper leak diagnoses should be performed in order to determine the cause of any refrigerant loss.
The electronic throttle assembly may suffer an electrical failure. It is often cheaper to send the valve to a service center for repair that to purchase a new part.
One or more of the following steering linkage components may wear prematurely; tie rod ends, drag link, or idler arm. Our technicians remind us the wheel alignment should be checked and adjusted if any of these items are replaced.
Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.