2001 Mercedes-Benz ML320 Problems
RepairPal has identified the most common problems with the 2001 Mercedes-Benz ML320 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Electrical switches in the door latches can fail, causing the door locks to rapidly actuate up and down multiple times when the locks are activated by either the keyless remote or door lock switch. The affected door latch should be replaced to correct this concern.
Door mounted storage pockets can become unglued and fall into the door.
The covering for the center console can bubble and discolor. Replacement of the affected part is most commonly only way to repair this concern.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern. A recall on certain 2000-2002 models have been recalled for a related issue - for more information please click here»
The power window switch may fail and the windows will not raise. The main switch at the front center console is commonly at fault. A failed switch will require replacement.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
The power steering return hose may leak at the radiator cooler fitting. If the clamp is not properly tightened, the hose can blow off, causing increased steering effort and a mess under the hood.
A no start condition may develop due to an anti-theft system fault. If the drive authorization module fails to recognize the keys, the engine will not start. In many cases, a new module and keys will be needed to correct this problem.
The heater blower motor can become abnormally noisy. Replacement of the blower motor is commonly necessary to correct this concern.
An exhaust leak may develop due to cracked welds on the front catalytic converter. Replacement of the catalyst is recommended; re-welding of the catalyst is discouraged because it is an emissions device.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.