An engine oil leak may develop from the oil level sensor. Replacement of the leaking sensor will commonly correct this concern.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 2002 Mercedes-Benz E55 AMG problems
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way toward the timing cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the cover and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
Instrument cluster displays tend to fail, especially the clock and gear indicators. Our technicians tell us the instrument cluster will require replacement to correct this issue.
A squeak from the steering column is often related to a rubber boot in the column or a seal in the power steering rack.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.
High mileage vehicles may develop a leak from one or more of the transmission oil seals.
PSE system, voice control module, or Tele Aid module failure can cause a lack of audio. These same modules can also cause dead battery conditions when they fail to "time out." Many electronic control modules are active even when the engine is off. If these modules stay active, they will drain the battery, which is why they have a timer built into the modules. The timer shuts down the modules after a preset amount of time (timing out). If a module does not time out, it will stay active and drain the battery.
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
Due to the size and material used on the brakes of these vehicles, the brakes may start to squeak around the 50 percent wear point. The brake rotor surfaces become uneven, causing a lip to form at the outer edge of the rotor. Because of this, the rotors are usually replaced when the pads are worn (pad life varies depending on driving style and terrain).