2008 Mercedes-Benz CL65 AMG Problems
RepairPal has identified the most common problems with the 2008 Mercedes-Benz CL65 AMG as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Engine misfires (rough running) and lack of power are commonly caused by ignition coil pack or ignition module faults. Proper diagnoses should isolate the cause and prevent unnecessary replacement of good parts.
High mileage or older vehicles commonly develop leaks from the differential seals and/or cover. Our technicians recommend a complete reseal of the differential unit whenever these leaks are repaired.
A vibration felt through the center floor of the vehicle can be caused by driveshaft flex discs, which crack and shred, causing excessive driveshaft movement. Not repairing these can cause damage to the driveshaft center support bearing, or, in the worst case scenario, damage to the transmission or differential.
Due to the size and material used on the brakes of these vehicles, the brakes may start to squeak around the 50 percent wear point. The brake rotor surfaces become uneven, causing a lip to form at the outer edge of the rotor. Because of this, the rotors are usually replaced when the pads are worn (pad life varies depending on driving style and terrain).
The center console armrest can break. Replacement is commonly the recommended repair.
Analog Tele Aid units are no longer supported and must be updated to digital, preferably at a dealership or a well-equipped independent shop. The update and all related factors should be completed at the same time.
The side window glass can delaminate. If this were to occur, replacement of the affected window would be necessary.
The electrical connector at the automatic transmission may leak fluid into the wiring harness. If not repaired, the oil will migrate through the wiring harness and damage the transmission control module. At that point, a new harness and control module may be necessary to correct this problem.
CD changers, command units, voice control units, PSE units, and Tele Aid units are prone to failure, especially in early models.
A door control module/actuator may fail. Our technicians recommend finding an expert to repair them. Taking the door trim panels off requires expert knowledge because they can break and the pieces are very expensive.
The door for the vanity mirror (or the frame for the door) can break; due to a redesign, the mirror "cassette" will need replacement.
The active body control system can leak fluid from numerous areas, including the tandem pump, hydraulic lines, struts, and/or seals. If it is not repaired, the vehicle ride height could drop too low and cause damage to the undercarriage.