Problem Reports
Problem with your car? See what our experts say or submit your own.
2007 Mercedes-Benz C350 4MATIC Problems
HVAC Oder Due to Mildew in Heater Box
The heating, ventilation and AC (HVAC) heater box is susceptible to mildew buildup. This can result in a musty odor from the HVAC system, most noticeable when the system is first turned on.
Tire Wear Caused By Worn Front Thrust Link Bushings
Irregular and premature tire wear can be caused by the front thrust link bushings cracking and causing excessive movement in the suspension. The thrust link bushings are fluid-filled (to help reduce vibration), so if they crack, they will leak oil.
Check Engine Light on Due to Failed Catalytic Converter
Catalytic converter failure is common and may cause a Check Engine Light to illuminate.
Flush brake fluid every two years
It is not uncommon to encounter premature failure of the anti-lock brake system (ABS) modulator assembly due to dirty brake fluid. Our technicians recommend flushing the brake fluid every two years in order to help prevent this problem.
Rough Shifting of Automatic Transmission
Vehicles equipped with a 7-speed automatic transmission may develop a rough shifting condition, most commonly going up from first to second gear and going down from third to second or second to first gear. Our technicians tell us this is due to an internal component failure. Mercedes has released updated parts; the transmission will need to be removed and disassembled to complete the necessary repairs.
Check Engine Light Due to Faulty Camshaft Adjuster Solenoid
The camshaft adjuster solenoid (which is related to the variable valve timing system) may fail or timing chain/balance shaft components may wear, resulting in illumination of the Check Engine Light and various drivability issues. Mercedes-Benz has released a service bulletin outlining specific repair instructions depending on fault codes stored.
Check Engine Light and Engine Misfire
Failed spark plug wires and/or ignition coils can cause intermittent misfires (rough running); the Check Engine Light may also illuminate. Diagnoses of the ignition system will be necessary to determine which components are at fault.
Inside Grab Handles/Upholstery/Door Trim Panels May Delaminate
Inside grab handles, the upholstery on the center console cover, and door trim panels can delaminate. Most commonly replacement of the affected part is necessary.
Knocking Noise Over Bumps Due to Worn Sway Bar Link Joints
The sway bar end link joints may wear and cause a knocking noise over bumps. Loose or warn links should be replaced to correct this type of noise.
Hold down nut for front strut may bacome loose
Dead Battery Due to Failed Seat Control Module
A dead battery can be caused by a faulty seat control module that does not properly shut down. Spilling liquids on the front seats can cause these modules to fail.
CD Changer May Suffer From Internal Mechanical Problem
The CD changer may suffer from an internal mechanical problem. Replacement of the faulty unit is generally required to correct this issue.
"Crank no Start" Due to Failed Crankshaft Position Sensor
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance. Communicating these specific symptoms to your technician can save diagnostic time.
SRS Light Due to Spilled Liquid on Buckle or Under Seat
The SRS (airbag) light can come on if liquids are spilled into the seat belt buckles, or if the liquid pools underneath the seat and gets into the electrical connector for the seat belt pretensioner. Damaged components will require replacement to restore proper airbag operation.
The Differential May Develop Leaks From the Seals or Cover
High mileage or older vehicles commonly develop leaks from the differential seals and/or cover. Our technicians recommend a complete reseal of the differential unit whenever these leaks are repaired.