1993 Mercedes-Benz 300SE Problems
RepairPal has identified the most common problems with the 1993 Mercedes-Benz 300SE as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower motor.
A faulty mass air flow (MAF) sensor can cause erratic/rough engine operation and fuel economy issues. Since this sensor measures the actual amount of air entering the motor, when it fails, the engine control module (ECM) takes the wrong information and delivers incorrect volumes of fuel to the cylinders.
A refrigerant leak may develop from one or more of the following AC components: AC compressor, hose manifold for the compressor, or the evaporator core. The loss of refrigerant can cause poor AC performance. Our technicians tell us that proper leak diagnoses should be performed in order to determine the cause of any refrigerant loss.
Failed ignition coil packs or spark plug resistors can cause a rough running motor or lack of power.
A cracked or broken heater core outlet housing can cause a coolant leak near the bulkhead (firewall). Our technicians remind us that coolant leaks should be repaired in order to avoid overheating the engine due to coolant loss.
The electronic throttle assembly may suffer an electrical failure. It is often cheaper to send the valve to a service center for repair that to purchase a new part.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
The tie rod ends, idler arm, and/or drag link components of the steering linkage may wear prematurely. Please keep in mind the wheel alignment should be checked and adjusted when any of these items are replaced.
The emissions air injection pump can seize, causing a loud squealing noise followed by smoke from the drive belt. If the engine is not turned off, the belt will break, turning on the alternator/battery warning light.
The lower control arm bushings can wear and crack, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear problems. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
A coolant leak may develop from the water pump. When replacing the water pump, the drive belt tensioner should be inspected and most likely replaced as well.
One or more door windows may stop working due to a failed window regulator. Replacement of the failed regulator will be necessary to correct this concern.
Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.
A coolant leak may develop form the Radiator due to degradation of its plastic components. Replacement of the failed radiator will be necessary.