1996 Mazda MX-6 Problem Reports

Most Reported 1996 Mazda MX-6 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

If the engine cranks but will not start, it may be due a failed distributor. In the diagnosis, it may be discovered that the Electronic Engine Control (EEC) Unit is the cause if ignition spark is restored after disconnecting the Spark Output (SPOUT) Connector.

Misfires under load (acceleration) can be caused by leaky spark plug boots. When a spark plug boot leaks, it allows the spark to arc, or jump, to the cylinder head. New spark plug wires will be needed.

If the engine cranks but does not start, it may be caused by a tripped inertia switch. Switch the key to "ON" and the fuel pump should be heard running for a second or two. Listen at the gas filler if necessary. If you do not hear the pump the inertia switch should be reset, it will "click" when it is reset.

A knocking sound heard from the front or rear suspension while driving over rough roads may be caused by the sway bar linkages. The linkages should be inspected for tightness and condition; there are redesigned linkages if replacement is necessary.

Vehicles with a V6 engine may develop an engine misfire under load (acceleration). This can be caused by a valve cover gasket leaking oil into a spark plug well, shorting the spark plug to the cylinder head. To repair this concern, the valve cover needs to be resealed and the spark plugs and wires should be replaced.