The accelerator position switch may fail intermittently resulting in sluggish acceleration or lack of power.
2005 Kia Amanti Problem Reports
Most Reported 2005 Kia Amanti Problem Reports
Reprogramming the transmission control module with the latest Kia transmission software may fix abnormalities in the automatic transmission and erroneous transmission-related Check Engine Light illumination. Software updates are commonly most effective on newer vehicles. Higher mileage vehicles may exhibit a similar symptom caused by a component failure. However, whenever major transmission repairs are performed the transmission software should be checked and updated as necessary.
A defective AC compressor clutch assembly can cause excessive noise or vibration when the air conditioning is on. Improved parts are available. Replacing the faulty clutch assembly does not necessitate replacement of the complete AC compressor or evacuation and recharging of the air conditioning system.
If the engine is excessively noisy on startup (after the engine has been off for several hours) and the noise lasts more than four or five seconds, turn off the engine and check for correct engine oil level. If the oil level is correct, the noise may be caused by the timing chain tensioner. Kia released an updated timing chain tensioner to solve this problem.
Poor drivability—or a hesitation on acceleration—after starting the engine when it's cold can be fixed by a simple reprogramming of the powertrain computer.
An engine misfire may develop due to a failed ignition coil. Our technicians tell us one coil is used for each cylinder. If one fails, often times another is not far behind. It may be worth considering replacing all the coils if a failure is encountered.
Make sure the transmission is filled with Kia-approved transmission fluid and at the correct level. Our technicians tell using incorrect transmission fluid or operating the transmission when it is low on fluid can result in internal transmission damage.
but it will start but the motor is making some noise. will it be safe to put the oil back in it and a new filter and fire it up