1999 Jeep Grand Cherokee Problem Reports

Most Reported 1999 Jeep Grand Cherokee Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

Temperature blend and recirculation doors commonly fail, which can cause the AC modes not to change or the temperature to be different on the left and right sides. If replacing blend air doors, a recirculation door, a door link, or a sub-assembly housing, new heating, ventilation and AC (HVAC) sub-assemblies are available that improve reliability.

The power window motor commonly fails in the front and rear doors. This may require replacement of the complete window regulator assembly which will include the window motor.

Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).

Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.

Electrical contacts in the tail lamp housing tend to break or melt, which can cause the brake lights to fail or work intermittently. Complete inspection of the tail light housing and bulbs is recommended before replacing any parts.

Failure in the blower motor power module (automatic temperature controls) or resistor block (manual AC) may cause the heater blower motor to work only on the high setting. The connector to the power module/resistor block is known to overheat (and sometimes melt). The connector or terminals should be replaced; a replacement connector is available.

Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.

The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops.  There is also a revised vacuum check valve available to address this concern.

The AC evaporator drain commonly clogs and causes water to leak onto the passenger side floor. A sloshing noise may also be heard from the water inside the heater housing. Decaying organic debris in the housing may cause an odor. A service bulletin (TSB 24-06-96) was released; it describes how to clean the drain tube without removing the heater AC housing.

If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.

The remote keyless entry system may not function intermittently. Our technicians tell us revised software for the wireless ignition node is available which can correct this concern.

A popping or groan type noise may occur when opening or closing one or more of the vehicle doors. This may be caused bu insufficient lube on the lower hinge roller axle. Applying a small amount of grease between the roller pin and the inside surface should correct this concern. Our technicians tell us if the grease is not applied in the correct location, the noise will remain.

When normal alignment practices do not bring components into the alignment specifications, offset upper ball joints are available.

The Check Engine Light may illuminate with any or all of the following codes: P2302, P2305, P2308, P2311, P2314, P2317, P2610. Our technicians tell us that updated software for the powertrain control module (PCM) is available to correct this concern.

During light to moderate braking, if you experience a vibration in the steering wheel, floor, or seat, or a minor pulsation in the brake pedal, installing revised front brake calipers may help. If the brake calipers are silver in color, they are up-to-date. If the calipers are black in color, the revised calipers are needed and should be installed along with new front brake rotors.