2009 Ford Mustang Problems
RepairPal has identified the most common problems with the 2009 Ford Mustang based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The Ford Mustang, with the 4.0L V6 engine, is known for a rough idle, engine stalling, loss of power, and misfires, accompanied by the check engine light.
The intake manifold O-ring gaskets commonly leak, which creates a large vacuum leak. This vacuum leak causes unmetered air to enter the engine, and the fuel system becomes insufficient to compensate for the large amount of air reaching the engine.
Replacing the intake manifold gaskets corrects this concern.
The 2005-2009 Ford Mustang with manual temperature and fan controls may have problems with the the blower motor only blowing air on certain settings. Most commonly the fan will only run on the highest setting. This is a well documented problem, and is caused by a failing blower motor resistor.
Correcting the problem is straight forward, and requires replacement of the small resistor. The resistor is normally found behind the glove box, next to the blower motor.
The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.
If a squeaking noise is heard while turning the steering wheel, the outer tie rod ends may be worn and should be replaced.
A creak/pop noise while turning may mean that updated steering rack bushing tubes need to be installed.
4.0L V6 engines may develop a buzzing type noise from the upper engine area at about 1900 RPM, under light acceleration. Our technicians tell us this can be caused by loose ignition coil bracket bolts. Coil bracket bolts should be checked for the correct torque before further diagnoses is performed.
The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.