» » »

Problems for specific Ford Mustang years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Most reported 2006 Ford Mustang problems

 

Verified for the Ford Mustang

If a squeaking noise is heard while turning the steering wheel, the outer tie rod ends may be worn and should be replaced.

26 Reports
Me Too

Verified for the Ford Mustang

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

15 Reports
Me Too

Verified for the Ford Mustang

A creak/pop noise while turning may mean that updated steering rack bushing tubes need to be installed.

15 Reports
Me Too

Verified for the Ford Mustang

The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.

14 Reports
Me Too

Verified for the Ford Mustang

4.0L V6 engines may develop a buzzing type noise from the upper engine area at about 1900 RPM, under light acceleration. Our technicians tell us this can be caused by loose ignition coil bracket bolts. Coil bracket bolts should be checked for the correct torque before further diagnoses is performed.

6 Reports
Me Too

Reported by mc54 and 3 others for the Ford Mustang

The adhesive holding the glass convertible window gives out and the window delaminates from the outer convertible shell. I used 3M VHB 2-sided adhesive tape (the same type that is used to hold glass panels to the outside of skyscrapers) to hold the window back in. It worked great, but long term effectiveness is still unknown.

4 Reports
Me Too

Reported by bmdouble and 1 other for the Ford Mustang

the pins will pull out of the connector for the transceiver ring,the connector is under the dash right above where your shins are.the wires pull out due to tilting the steering wheel and not enough slack in the harness.

2 Reports
Me Too
Ask a Question