2005 Ford F-150 Problems
RepairPal has identified the most common problems with the 2005 Ford F-150 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing differential clutch kit. An updated differential clutch kit available.
There is a technical service bulletin for the V8 engines regarding a possible problem with the spark plug being ejected from the cylinder head, damaging the threads in the spark plug hole. If the vehicle is under warranty, cylinder head replacement is recommended. If the vehicle is out of warranty, Ford authorized the use of a specific thread insert to repair the head.
The engine oil pan gasket can develop a leak. Leaking oil may accumulate on the exhaust system resulting in a burning smell. Replacing the gasket should correct this leak.
The 2004-2014 Ford F-150 with manual temperature and fan controls may have problems with the the blower motor only blowing air on certain settings. Most commonly the fan will only run on the highest setting. This is a well documented problem, and is caused by a failing blower motor resistor.
Correcting the problem is straight forward, and requires replacement of the small resistor. The resistor is normally found behind the glove box, next to the blower motor.
Our technicians tell us the spark plugs in this engine can be very difficult to remove. Ford has issued a service bulletin (08-7-6) to address this issue, which includes a recommended procedure on how to remove the plugs. Failure to follow the recommended procedure can result in the one or more spark plugs breaking off in the cylinder head.
The recommend procedure is as follows. Using this procedure will greatly reduce the chance of breaking a spark plug.
1. Break the spark plugs loose when the engine is warm.
2. Turn each plug 1/8 to 1/4 turn and soak the treads with 1/2 to 3/4 teaspoon of Motorcraft Carburetor Tune-Up Cleaner or a quality penetrating oil. Do not try to remove the plugs at this time.
3. Let the threads soak for at least 15 minutes.
4. After the soak period, tighten and loosen each spark plug, working it back and forth until the turning effort is reduced. Then, you can remove the spark plug.
There are special tools available to remove the broken spark plugs and repair shops will often charge additional labor time, over and above the quoted spark plug replacement cost, for the removal of each broken spark plug.
On higher mileage vehicles, one or more EGR orifice in the intake manifold may plug with sludge. This can cause the engine to misfire when first accelerating because too much exhaust gas is directed into the cylinders where the orifice is not plugged. Cleaning the clogged passages should correct this concern.