2011 Ford Escape Hybrid Problems
RepairPal has identified the most common problems with the 2011 Ford Escape Hybrid based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
Many customers state that whule driving their vehicle, the engine will hesitate, stumble, or lose power. In more severe cases, the EGR valve can be physically damaged. In all cases, the check engine light will be illuminated, and diagnostic trouble codes will be stored in the PCM.
Diagnosis of the issue has concluded the differential pressure feedback EGR sensor (DPFE) is at fault many times, and incorrectly measures exhaust gas re-circulation (EGR) pressure.
Correction of the issue requires a diagnostic scan, identification of the faulty sensor, and, ultimately, the sensor and EGR valve may require replacement. In some models, the DPFE sensor is integrated into the EGR valve, and must be replaced together.
The 2008-2012 Ford Escape Hybrid with automatic climate control may have a problem with frequent fan speed changes when using the heater or air conditioner. Normally, the fan speed changes only to maintain a selected temperature, but when the fan speed changes frequently and needlessly, there is an issue with the fan speed control unit.
The fan speed control unit, sometimes erroneously called the blower motor resister, regulates the speed for the blower motor in order to maintain the temperature set by the driver. When it fails, the fan will run at random settings, and the climate control will be inaccurate.
Note: this does not affect the temperature of the air that comes from the vents, it affects the amount of air that comes from the vents.
The repair is simple, and quick. The control unit is located behind the glove box in most models, and removal and installation takes only minutes.
Also note: this only applies to vehicles with single or dual automatic climate control.
The 2008-2012 Ford Escape Hybrid with manual temperature and fan controls may have problems with the the blower motor only blowing air on certain settings. Most commonly the fan will only run on the highest setting. This is a well documented problem, and is caused by a failing blower motor resistor.
Correcting the problem is straight forward, and requires replacement of the small resistor. The resistor is normally found behind the glove box, next to the blower motor.