2009 Dodge Ram 2500 Problems
RepairPal has identified the most common problems with the 2009 Dodge Ram 2500 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
If the engine does not crank (or cranks but won't start), the wireless control module (WCM) may have locked up. This is due to static discharge through the ignition key. A revised model should be installed, but simply disconnecting the negative terminal of the battery for thirty seconds will temporarily reset the module so you can start the car.
On some models a void in the rear window seal may cause a water leak. Water may be present on or under the carpet. The seal will need to be replaced if that is the source.
The transfer case in the Dodge Ram 2500 has multiple gear ratios, which can be selected by moving the switch in the cabin to 2Hi, 4Hi, or 4Lo. It has been known to shift to 4Lo without warning, at any speed, and whether the vehicle is on or off. If this occurs at highway speeds, the result can be catastrophic failure of the transfer case.
This is caused by a faulty four wheel drive shift motor, selector switch (in the cab) or the wiring between the two. The most common cause is the transfer case switch, which is an electric motor mounted on the transfer case.
To correct the issue, inspect the wiring to the transfer case switch motor for damage, and replace the shift motor if needed. Disconnecting power to the shift motor will lock the transfer case in its current setting.
If a clunking or "loose lumber" noise is coming from the front or rear suspension, there are revised shock absorbers available that can help the concern. This is usually heard at lower speeds and colder temperatures when driving over bumps.
Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.