1995 Chrysler LeBaron Problems
RepairPal has identified the most common problems with the 1995 Chrysler LeBaron as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Vehicles may develop a start and die out condition or a transmission that defaults to second gear. Our technicians tell us that the transmission control module (TCM) may be at fault and require replacement. If the TCM is replaced the pinion factor should be reset and the quick learn procedure performed.
The anti-lock brake (ABS) warning lamp may illuminate with "Modulator Fault" indicated by a scan tool. This would indicate a electrical fault, commonly caused by a faulty connection. ABS connectors should be inspected for problems if this situation occurs.
Automatic transmissions can exhibit a variety of shifting and noise concerns due to failure of internal parts. Our technicians tell us that a complete inspection of all internal parts should be performed if the transmission is disassembled for overhaul. Numerous updated part are available for this transmission.
The connector on the input and/or output speed sensors on the automatic transmission may become damaged causing intermittent loss of speed control. There are wiring repair kits available to repair this issue.
Engine oil leaks may develop from the following areas: Valve cover gaskets, cam plugs at rear of the cylinder head, cam seals, front crankshaft seal, and the oil filter bracket. Leaking seals and gaskets should be replaced. Due to mis-machining of the mating surfaces, as special gasket is required to correct the oil filter bracket leak.
Carbon buildup on the top of the piston is common. Over time this can lead to symptoms varying from light ticking to knocking noises. Performing a fuel injector cleaning procedure can often help the condition by removing some of the piston top deposits.
3.0L engines may develop an excessive oil consumption issue. Blue oil smoke may be noted from the exhaust during deceleration conditions (high engine vacuum). Our technicians tell us that this condition can be caused by valve guides dropping out of position. Updated valve guides with a revised snap ring grove are available to correct this issue.
One or both front power windows may not roll up. This can be the result of the lift plate down stop bending, allowing the rollers to come out of the track. Our technicians tell us there is an updated window lift plate to correct this concern.
A tappet/lash adjuster noise may be noted from 3.0L engines. Our technicians tell us that proper testing of the valve lash adjusters should be performed before replacing any parts. A full crankcase of clean engine oil is necessary before determining if any lash adjusters are bleeding down and causing a noise concern.