1995 Chrysler Cirrus Problem Reports

Most Reported 1995 Chrysler Cirrus Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The spark plug tube seals may fail, causing the tubes to fill with engine oil and the engine to misfire. As a result, the engine may run poorly and fuel economy can suffer.

If the car will not start, stalls, or hesitates while accelerating, it may be caused by wires in the wiring harness that are broken internally. This is typically found where the wires pass under the distributor.

There have been reports of premature head gasket failure; an updated gasket design is available to correct this problem.

Defective speed sensors on the transmission can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors can corrode and/or the connector terminals can spread (poor connection), which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.

 

The automatic transmission used in these vehicles have had a high failure rate. Failures can be due to internal component or electrical component failure.

One or both windshield washer nozzles may plug or clog. There are revised washer nozzles available which are more resistant to plugging.

Some vehicles may develop a musty odor coming from the HVAC system, Dodge has issued a cleaner/disinfectant and a coating for the evaporator designed to inhibit bacterial growth.

An engine Oil leak may develop at the cam sensor o-ring seal. Our technicians tell us this is often misdiagnosed as an external head gasket leak.

If a Check Engine Light illuminates indicating leak detection pump (LDP) failure, the cause is often pinched or disconnected vacuum lines to the pump. Vacuum lines should be inspected before replacing the leak detection pump. Contamination (carbon or debris) in the pump can cause failure and any hoses should be cleared before a new pump is installed.

Check Engine (MIL) light illumination, along with hard starting or a rough engine idle, can be caused by the EGR valve; a revised EGR valve is available.

When a no start condition is caused by a faulty camshaft or crankshaft sensor, related fault codes stored in the powertrain control module (PCM) should not be trusted. Our technicians tell us that under certain conditions a fault code can be stored for the "good" sensor. Care should be taken to properly diagnose this condition.

I have an oil leak in my 1995 Chrysler cirrus. Has there been anyone else with this problem and how did you fix it?

The was a recall on some models to inspect the front, lower ball joints and replace any that are damaged.

There was a recall on some models to replace the brake master cylinder due to potential leaks.

way to go Chris, you tha man!