Problem Reports

The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.

The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.

A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.

A clicking noise may be noted from the turn signal flasher after the turn signals are switched off.  This is commonly cause by a faulty turn signal switch which will require replacement.

GM 8-Lug vehicles are known to have a front bushing problem in the lower control arm. To prevent this problem from causing more problems further down the road, the problem should be fixed now. The front bushings work themselves out of the lower control arms. The solution is to press out the front bushing and press it back in from the other direction. Instead of the bushing being pressed in from the front of the truck toward the back, the bushi...