2002 Cadillac Seville STS Problems
RepairPal has identified the most common problems with the 2002 Cadillac Seville STS as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
A Loose or worn gas cap may cause Check Engine Light to illuminate.
One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.
Problems with anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The key and ignition lock cylinder should be replaced to correct this condition.
The high-pressure power steering lines are known to leak.
Vehicles equipped with the 4.6L engine may develop excessive oil consumption. Please be advised that under optimum driving conditions, using one quart of oil every 2000 miles is acceptable. This Cadillac standard applies to vehicles with less that 50,000 miles. Our technicians tell us that if you experience excessive oil consumption it may be caused by built up on the piston rings which restricts movement, preventing them from wiping all the oil from the cylinder walls. Oil left behind is then burned during the combustion process. There is a special ring cleaning procedure which can help this situation. The GM service bulletin number is #02-06-01-009C.
This powertrain control module (PCM) may develop a fault with its electrical ground location at the front of the engine block near the starter motor.
The electronic level ride system may not work properly; this may result in the rear of the vehicle riding too high or too low. Our technicians tell us that a height sensor or exhaust valve failure are common issues with this system. Proper diagnoses will be necessary to confirm the exact fault.
The trunk pull down switch may fail causing the trunk lid not to close completely. Our technicians tell us that the failed switch can be replaced without changing the complete pull down motor assembly.