2000 Cadillac Seville Problems

RepairPal has identified the most common problems with the 2000 Cadillac Seville as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
24
Known Problems

The crankshaft position sensor may fail causing the engine to stall intermittently, the Check Engine Light may or may not illuminate.

One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.

The parking brake may not release automatically due to a failed vacuum switch or actuator. Our technicians tell us that if vacuum is supplied to the actuator when the transmission is in gear, the vacuum switch is functioning and replacing the actuator should correct this concern.

Illumination of the Check Engine Light may be the result of a loose or worn gas cap.

Water may be drawn into the secondary air injection (AIR) pump causing the pump to fail and the Check Engine Light to illuminate. Our technicians tell us there is a kit available from General Motors to relocate the air intake for the pump which should prevent future damage from water intrusion.

An ignition coil may fail causing one of the cylinders to misfire. Each of the two banks of cylinders has its own coil assembly. If one ignition coil fails the coil assembly for the corresponding cylinder bank must be replaced.

You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed.

Vehicles equipped with the 4.6L engine may develop excessive oil consumption. Please be advised that under optimum driving conditions, using one quart of oil every 2000 miles is acceptable. This Cadillac standard applies to vehicles with less that 50,000 miles. Our technicians tell us that if you experience excessive oil consumption it may be caused by built up on the piston rings which restricts movement, preventing them from wiping all the oil from the cylinder walls. Oil left behind is then burned during the combustion process. There is a special ring cleaning procedure which can help this situation. The GM service bulletin number is #02-06-01-009C.

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.

Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.

Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.

An intake manifold vacuum leak can develop from a variety of sources, often causing illumination of the Check Engine Light with codes P0171 & P0174 stored. Thorough diagnoses will be necessary to pinpoint the cause in order to make the correct repairs. A "smoke" machine is often used to isolate the cause of difficult to find vacuum leaks.

Overheating of the engine may cause the cylinder head to expand, severely straining the head bolts and damaging the threads in the engine block. This commonly results in a blown head gasket. Our technicians tell us the engine block threads must be repaired before the cylinder head is reinstalled.

The engine may develop oil leaks from the lower crankcase portion of the engine block. Our technicians tell us that the engine must be removed from the vehicle to properly repair this oil leak.

The EGR valve may stick open, causing a rough idle and/or the Check Engine Light to illuminate.