The engine may develop an oil leak from the lower crankcase portion of the engine block. Our technicians tell us that the engine must be removed from the vehicle to properly repair this oil leak.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 2007 Cadillac DTS problems
Service Stability Message Due to Failed Steering Wheel Position Sensor
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
Transmission Fluid Leak From Cooler Line
An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.
The Fuel Pump May Fail Causing the Engine to Stall or Crank Over But Not Start
The fuel pump may fail causing the engine to stall and not restart.
Coolant Leaks From Water Pump and Radiator
The water pump and/or the plastic side tanks on the radiator may leak causing a loss of coolant. The engine may overheat due to coolant loss. Continued coolant loss after external leaks have been repaired could indicate a blown head gasket.
Check Engine Light Due to Gas Cap Issue
A Loose or worn gas cap may cause Check Engine Light to illuminate.
The Parking Brake May Not Automatically Release
The parking brake may not release automatically due to a failed vacuum switch or actuator. Our technicians tell us that if vacuum is supplied to the actuator when the transmission is in gear, the vacuum switch is functioning and replacing the actuator should correct this concern.
ABS Light Due to Control Module Failure
The anti-lock brake system (ABS) control module may fail causing the ABS light to illuminate. Failed modules should be replaced to restore ABS operation.
Engine Overheating Due to Leaking Headgasket
Overheating of the engine may cause the cylinder head to expand, severely straining the head bolts and damaging the threads in the engine block. This commonly results in a blown head gasket. Our technicians tell us the engine block threads must be repaired before the cylinder head is reinstalled.
Stalling Due to Failed Crankshaft Position Sensor
The crankshaft position sensor may fail causing the engine to stall intermittently, the Check Engine Light may or may not illuminate.
Check Engine Light Due to Engine Vacuum leak
The Check Engine Light may illuminate due to an engine vacuum leak from the intake manifold area.
Rough Idle Due to EGR Valve Sticking Open
The EGR valve may stick open, causing a rough idle and/or the Check Engine Light to illuminate.
Misfire and/or Check Engine Light Due To Failed Ignition Coil
An ignition coil may fail causing one of the cylinders to misfire. Each of the two banks of cylinders has its own coil assembly. If one ignition coil fails the coil assembly for the corresponding cylinder bank must be replaced.
INTERMITTANT HEAD LAMP OPERATION
HEAD LAMPS ( HIGH INTENSITY TYPE HAD INTERMITTANT OPERATION CAUSE WIRING PLUG CONNECTION AT HEAD LAMP ASSYBLY OVER HEATED AND BURNT ) REPAIR IS TO REPLACE HEAD LAMP ASSYMBLY"S AND WIRING PLUG DEALER REPAIR
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers