2000 Audi A6 Quattro Problem Reports

Most Reported 2000 Audi A6 Quattro Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The digital display portion of the instrument cluster may fail. Our technicians tell us the entire instrument cluster will need to be replaced to correct this concern.

The anti-lock brake system (ABS) control module may fail causing the ABS light to illuminate. Failed modules should be replaced to restore ABS operation.

A fluid leak may develop from the propeller shaft seal on the rear of the transmission. Our technicians tell us that replacing the seal will commonly correct this concern.

Vacuum leaks, oxygen sensor failure, and catalytic converter efficiency faults can cause the Check Engine Light to illuminate.

Our technicians recommend having the constant velocity (CV) boots and CV joints inspected at each service. Servicing torn CV boots early can prevent the need to replace the CV half shaft or CV joint.

Premature wear in various multi-link suspension components can cause noises that are difficult to diagnose. Worn suspension parts can also cause uneven tire wear and create steering alignment problems.

Engine oil leaks are common from the valve cover gaskets and camshaft chain tensioner gasket.

The water pump may fail resulting in engine overheating and possible timing belt damage. Overheating and/or timing belt failure can result in very expensive engine repairs. As a precaution, it is recommended to inspect the timing belt and water pump at regular intervals.

Clogged sunroof drains can allow water to enter the interior and accumulate under the carpet where various control modules are mounted. Over time, the accumulated moisture can damage the control modules.

Erratic turn signal operation can be a result of a failing turn signal flasher relay which will require replacement.

An ignition coil or spark plug may fail unexpectedly resulting in an engine misfire and possible illumination of the Check Engine Light.

Clogged drains can allow rainwater to accumulate in the plenum tray (at the base of the windshield). The water may leak into the vehicle's interior, brake booster, or electrical components, which can lead to major problems. Our technicians recommend keeping the tray clear of leaves, pine needles, and other debris.