» » 3500

Resources for the Repair and Maintenance of your Ram 3500

Ram 3500 Models:

Ram 3500 Recalls (Recent)

Brakes, December 7, 2010

RepairPal Expert Overview:

Chrysler is recalling certain 2010-2011 Dodge Ram trucks equipped with a diesel engine and hydroboost brake system because the brake pedal may be slow to return after brake application. A slow returning brake pedal will cause the brake lights to be slow to extinguish, which can increase the risk of a crash. Dealers will replace the power steering reservoir cap in order to lessen the vent pressure in the reservoir.

Learn more »

Electrical & Lights, June 4, 2013

RepairPal Expert Overview:

If there is a problem with the turn signal system the signal indicator on the dash should flash at double its normal rate. These 2013 Ram trucks are being recalled because this may not occur and the driver could unknowingly continue to use the turn signals believing the system was operating normally. Dealers will reprogram the Central Body Controller software to correct this concern.

 

Learn more »

Electrical & Lights, June 4, 2013

RepairPal Expert Overview:

Certain headlight systems use an adjustable "shutter" which is mounted in front of the headlight bulb and partially blocks the beam depending on the high/low beam selection. Certain 2013 Ram 2500 and 3500 trucks are being recalled because the shutter may not function correctly in the high beam mode, resulting in too much or too little illumination. Improper illumination can result in reduced driver visibility or blinding of oncoming traffic, increasing the risk of a crash. Dealers will reconfigure the Central Body Controller to correct this concern.

Learn more »

Engine, April 3, 2013

RepairPal Expert Overview:

Most modern engine are have a cosmetic cover on top of the engine. On these vehicles, this cover can trap an excessive amount of heat, resulting in an under hood fire. Dealers will replace the engine cover with a revised design to correct this concern.

Learn more »

Suspension & Steering, July 6, 2011

RepairPal Expert Overview:

Certain vehicles may have been assembled with a left outer tie rod ball stud that may fracture; others may have received the affected tie rod assembly as a replacement part during normal service. This condition tends to occur during low speed parking lot type maneuvers when the driver is making a tight turn. This condition could result in a loss of directional stability in the left front wheel, increasing the risk of a crash. Dealers will inspect the tie rod ends, replace the left outer tie rod end as required, and perform a front end toe alignment as needed. The manufacturer has not yet provided an owner notification schedule. The Chrysler recall number is L16.

Learn more »

Ram 3500 Questions and Answers

bryantbass33, 2013 Ram 3500, 6.7L 6 Cylinder Diesel Turbo, Winnsboro, SC

I had a issue with the waste and a loss of power they fixed that but maybe my turbo is dirty

Ram 3500 Model Years
More about this car
Recent Ram Repair Estimates