2000 Plymouth Grand Voyager Problem Reports

Most Reported 2000 Plymouth Grand Voyager Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

One or more power windows may stop working due to a failed window motor or regulator. In some cases these items are replaced as a set. If not, diagnoses will be required to determine which is at fault.

On higher-mileage vehicles, engine oil leaks from the valve covers and front crankshaft seal are common.

Illuminated of the airbag warning light may be caused by a lost connection between the clockspring (behind the steering wheel) and the steering wheel-mounted electrical components. Other steering wheel-mounted controls like the horn, speed (cruise) control, or radio controls (if equipped) may be inoperative. There is a lifetime warranty on the clockspring as specified in a combination of recall campaigns. For more information on these recalls please us the following links; 1996-1998 models, please click here». For 1998-2000 models, please click here»

Hood misalignment, cowl cover misalignment, wiper module drain tube(s), and/or the lower plenum drain hose may cause the HVAC housing to leak water onto the passenger side floor. Diagnoses will be required to confirm the location of a water leak in the front passenger area.

Intermittently, the key may not start the car or release from the ignition. If it is excessively worn, replace the key. If the new key doesn't work, replacing the lock cylinder including tumblers should correct this concern.

If the door lock actuators (integrated into the door latch assembly) are noisy and/or not working, the latch should be replaced. For some model years, the actuator for the sliding door is available separately from the latch.

A delay in the transaxle engagement (greater than three seconds) may have multiple causes, including a defective pump, defective internal lip seals, valve body components, park-reverse-neutral-drive lever switch, and the output speed sensor. Proper diagnoses will be necessary to determine the exact cause.

A dirty throttle body may cause low engine idle speed or frequent stalling, as oily residue blocks air flow in the throttle when the throttle is closed. Throttle body cleaning may be necessary to correct this condition. Our technicians caution against spraying cleaner directly onto the throttle body as this may damage the throttle position sensor (TPS).

Oil leaks at the valve cover gaskets and cam plugs at the rear of the cylinder heads are common.
Oil may seep from between the oil filter bracket and the cylinder block. Polishing the mating surfaces between the bracket and the cylinder block (to remove rough machining marks) will fix the problem.
Spilling beverages around the cup holder may cause the lid to stick or bind. To fix the problem, remove and wash the cup holder with dishwashing soap and water and apply lubricant to the sliding mechanism.
While driving through deep or blowing snow/water, moisture may enter the rear brake drums, causing rust to develop on the rear brake drum and shoe friction surfaces. Over time, repeated (and sometimes infrequent) exposure to the snow can lead to temporary freezing of the rear brake linings to the drums. A revised brake drum and brake drum backing plate is available.

Some vehicles may develop a musty odor coming from the HVAC system, Dodge has issued a cleaner/disinfectant and a coating for the evaporator designed to inhibit bacterial growth.

AWD equipped vehicles can show a wide range of transmission problems, often caused by using the wrong-sized and/or mismatched tires. Be sure that all the tires are the same and that all four are replaced at the same time. Dodge recommends tire rotation every 7,500 miles.

Timing cover oil and coolant leaks are common, the oil and coolant don't normally mix. Our technicians recommend to replace the timing chain and cam sprocket if the timing cover is removed to reseal - or for any other reason.