1998 Plymouth Grand Voyager Problems
RepairPal has identified the most common problems with the 1998 Plymouth Grand Voyager based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
Hood misalignment, cowl cover misalignment, wiper module drain tube(s), and/or the lower plenum drain hose may cause the HVAC housing to leak water onto the passenger side floor. Diagnoses will be required to confirm the location of a water leak in the front passenger area.
Illuminated of the airbag warning light may be caused by a lost connection between the clockspring (behind the steering wheel) and the steering wheel-mounted electrical components. Other steering wheel-mounted controls like the horn, speed (cruise) control, or radio controls (if equipped) may be inoperative. There is a lifetime warranty on the clockspring as specified in a combination of recall campaigns. For more information on these recalls please us the following links; 1996-1998 models, please click here». For 1998-2000 models, please click here»
A malfunctioning switch in the steering column can cause the front windshield wipers to self-activate or not turn off. A failed windshield switch will require replacement.
A momentary loss of power steering can occur when the AC or defroster is on during high humidity conditions. This is due to condensation from the evaporator draining onto the serpentine belt. To fix the problem, a spout on the AC evaporator drain and a new serpentine belt should be installed. Some vehicles may need a revised serpentine belt tensioner.
If you hear a popping, clunking, or snapping sound from the front of the vehicle after five miles of driving on smooth surfaces, the outer tie rod ends may be worn and require replacement.
On higher-mileage vehicles, engine oil leaks from the valve covers and front crankshaft seal are common.
Defective speed sensors on the transmission can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors can corrode and/or the connector terminals can spread (poor connection), which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.
Intermittently, the key may not start the car or release from the ignition. If it is excessively worn, replace the key. If the new key doesn't work, replacing the lock cylinder including tumblers should correct this concern.
A dirty throttle body may cause low engine idle speed or frequent stalling, as oily residue blocks air flow in the throttle when the throttle is closed. Throttle body cleaning may be necessary to correct this condition. Our technicians caution against spraying cleaner directly onto the throttle body as this may damage the throttle position sensor (TPS).
The speedometer may become inoperative due to a failed vehicle speed sensor (VSS), . A failed sensor will require replacement.