2007 Mercury Milan Problems
RepairPal has identified the most common problems with the 2007 Mercury Milan as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The automatic transmission may develop shifting concerns. On lower mileage vehicles, upgrading the software in the powertrain control module (PCM) and the transmission control module (TCM) may correct the problem. As the mileage increases, internal transmission damage can occur. Repairs could involve replacement of the valve body or a complete transmission rebuild. Whenever major transmission repairs are made, it is important to be sure the PCM and the TCM have the latest software updates to help prevent these issues from reoccurring.
If the key will not come out of ignition, this may be related to problems with the shifter knob sticking and / or binding of the shifter bezel. Replace the shifter knob and / or shifter bezel as needed.
The check engine light may come on due to failure of the Variable Camshaft Timing (VCT) solenoids. The VCT solenoids will need to be replaced if they are the reason the check engine light came on.
Squeaks and creaks heard while driving over bumps and turning can be caused be a couple common sources and should be carefully diagnosed. Possible weld issues on the lower control arms can cause the noise concerns and require repair kits for the lower control arms from Ford. A jounce bumper (bump stop) rubbing against dry strut plate can cause an abrasion noise from the strut area. In this case the strut assembly should be disassembled to lubricate the jounce bumper and then reinstalled.
Electrolysis can cause repeated failures of the heater core and radiator. The diagnosing technician should check for voltage present in the coolant, with the battery disconnected, because electrical current in the coolant causes electrolysis. Corroded or deteriorated parts should be replaced, and the coolant should be flushed. Ground straps can be added to help prevent future corrosion of components.
The electric trunk latch solenoid can get stuck in the open position making it so the trunk will not latch closed. The diagnosing technician should verify correct electrical connection at the solenoid and check for correct cable routing. The trunk latch most commonly will need to be replaced.