» » »

Problems for specific Isuzu Hombre years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Most reported 2000 Isuzu Hombre problems

 

Verified for the Isuzu Hombre

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

8 Reports
Me Too

Verified for the Isuzu Hombre

The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.

7 Reports
Me Too

Verified for the Isuzu Hombre

A Loose or worn gas cap may cause Check Engine Light to illuminate.

6 Reports
Me Too

Verified for the Isuzu Hombre

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

5 Reports
Me Too

Verified for the Isuzu Hombre

The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module assembly if this condition occurs.

3 Reports
Me Too

Verified for the Isuzu Hombre

A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.

2 Reports
Me Too

Verified for the Isuzu Hombre

The CD player in the radio may fail. Our technicians tell us that the radio will need to be removed and sent out to a radio repair shop to correct this condition.

1 Report
Me Too

Verified for the Isuzu Hombre

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

1 Report
Me Too
Ask a Question