2007 GMC Yukon XL Denali Problems

RepairPal has identified the most common problems with the 2007 GMC Yukon XL Denali as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
12
Known Problems

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

The rear window defogger may stop working due to a wire terminal broken off of the rear glass. Our technicians tell us that terminal can be reattached using a special glue or silver solder.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.

A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.

Our technicians recommend flushing the brake fluid every 60,000 miles.  Brake fluid that is dirty may cause problems in the brake system.

The battery may leak acid at the battery cable connections. As a result corrosion may form on the battery cable ends. Leaking batteries should be replaced and the cables need to be thoroughly cleaned or replaced if necessary.

Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
Our technicians highly recommend that the transmission is serviced every 30,000 miles to avoid problems and maintain optimal operating order.

The keyless entry system may stop working. Our technicians tell us the key fobs and keyless entry receiver may need to be replaced to correct this fault.

The steering wheel position sensor may fail, resulting in the service stability message being displayed.