2009 GMC Yukon XL 1500 Problems
RepairPal has identified the most common problems with the 2009 GMC Yukon XL 1500 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
The 2008-2014 GMC Yukon XL 1500 uses a throttle position sensor (TPS) which commonly fails and causes:
- Check engine light illumination
- Reduced Power message
- OBD trouble code P2135
This issue is related to the throttle position sensor, and can be caused by faulty wiring to the TPS, bad connection at the TPS, or a failed TPS.
To correct this issue, the wiring harness, connector, and throttle position sensor must be inspected, tested, and/or replaced. The most common cause is a faulty TPS.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.