Problem Reports
Problem with your car? See what our experts say or submit your own.
2002 GMC Yukon XL 1500 Problems
Service 4WD Message May be Displayed
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
Daytime Running Lights are Prone to Burning Out
The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2000-2003 models is #4114K (trade number).
Steering May Develop Clunk Noise From Upper Intermediate Steering Shaft
The steering may develop a clunk type noise from the upper intermediate steering shaft. Our technicians tell us that you should check with you local GM dealer to find out what the latest repair is for this condition.
Sunroof May Stop Working
The sunroof may stop working for various different reasons. Our technicians tell us it is often better to replace the complete sunroof assembly than to try and repair the old one.
Popping Noise From Muffler Heat Shield
The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.
Improper HVAC Temperature and/or Air Delivery Due to Failed Mode Door Actuator
One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.
Rear Window Defogger Wire Terminal Broken Off of Window Glass
The rear window defogger may stop working due to a wire terminal broken off of the rear glass. Our technicians tell us that terminal can be reattached using a special glue or silver solder.
Service Stability Message Due to Failed Steering Wheel Position Sensor
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
Stalling or Low Engine Idle Speed Due to Dirty Throttle Body
A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.
Check Engine Light Due to Restricted Secondary Air Injection Check Valve
One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.
Clicking Noise From Flasher When Turn Signals are Off
A clicking noise may be noted from the turn signal flasher after the turn signals are switched off. This is commonly cause by a faulty turn signal switch which will require replacement.
ABS Light Due to Poor Electrical Ground Under the Battery Tray
A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.
Parking Brake Does Not Hold Due to Worn Parking Brake Shoes
Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.
Check Engine Light Due to Gas Cap Issue
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
Erratic Fuel Gauge Operation
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers