2000 GMC Yukon XL 1500 Problems

RepairPal has identified the most common problems with the 2000 GMC Yukon XL 1500 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
26
Known Problems

The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.

The sunroof may stop working for various different reasons. Our technicians tell us it is often better to replace the complete sunroof assembly than to try and repair the old one.

The steering wheel position sensor may fail, resulting in the service stability message being displayed.

A rattling noise may develop from the AC belt tensioner. This can be caused by an internal fault with the AC compressor, AC performance may also be diminished when this occurs. Our technicians tell us that replacing the ac compressor will commonly correct this concern.

 

The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2000-2003 models is #4114K (trade number).

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.

Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.

A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.

The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.

A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.

The battery may leak acid at the battery cable connections. As a result corrosion may form on the battery cable ends. Leaking batteries should be replaced and the cables need to be thoroughly cleaned or replaced if necessary.

The anti-lock brake system (ABS) pump may stay running after the ignition is turned off causing the battery to go dead. Our technicians tell us that the ABS control module should be replaced to correct this fault.

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.