2000 GMC Sierra 1500 Problems

RepairPal has identified the most common problems with the 2000 GMC Sierra 1500 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
26
Known Problems

The GMC Sierra 1500 has a known issue with the air pump check valve which causes illumination of the check engine light. There are no notable symptoms, but the vehicle will not pass state inspection or smog testing. 

When the valve fails, it sticks closed, and the computer sets the code P1416. Replacement of the check valve is the only fix, as the valve is not serviceable. 

This page can provide more information about the air pump check valve. 

The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault. The warranty has been extended on some of these units to 7 years or 70,000 miles.

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.

The inside door handles are prone to breaking.

Our technicians highly recommend that the transmission is serviced every 30,000 miles to avoid problems and maintain optimal operating order.

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.

The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 1999-2003 models is #4114K (trade number).

The CD player may fail due to an internal fault with the radio. Our technicians tell us that in most cases, the radio unit will need to be sent to a specialty repair shop to correct this issue.

A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.

Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.

A rattling noise may develop from the AC belt tensioner. This can be caused by an internal fault with the AC compressor, AC performance may also be diminished when this occurs. Our technicians tell us that replacing the ac compressor will commonly correct this concern.

 

The steering may develop a clunk type noise from the upper intermediate steering shaft.  Our technicians tell us that you should check with you local GM dealer to find out what the latest repair is for this condition.

The steering wheel position sensor may fail, resulting in the service stability message being displayed.

The fuel pump may fail causing the engine to stall and not restart.